kid
05-08-2009, 11:32 PM
Squeeze, this is how my MachII looks.
http://www.varminthunters.com/forum/images/editor/attach.gif
The stock is a Fajen thumbhole sporter. I had to put a pressure pad at the fore end to get the accuracy I wanted, something I've had to do to all my heavy barrel 10/22's. The barrel and bolt handle/spring are from Numrich Arms. As I am frugal (cheap) I did the trigger and bolt work myself. If you are so inclined and patient it isn't hard. That said, I'm a machinist by trade, so I'm used to working tight tolerances. Just remember it's easier to check than it is to weld and heat treat, so take your time and check dimensions often.
Sorry it took so long to post, I mentioned cheap earlier, my connection is dial up. Yes I still listen to vinyl and watch VHS tapes. My car has a cassette player too!:D
Paul
http://www.varminthunters.com/forum/images/editor/attach.gif
The stock is a Fajen thumbhole sporter. I had to put a pressure pad at the fore end to get the accuracy I wanted, something I've had to do to all my heavy barrel 10/22's. The barrel and bolt handle/spring are from Numrich Arms. As I am frugal (cheap) I did the trigger and bolt work myself. If you are so inclined and patient it isn't hard. That said, I'm a machinist by trade, so I'm used to working tight tolerances. Just remember it's easier to check than it is to weld and heat treat, so take your time and check dimensions often.
Sorry it took so long to post, I mentioned cheap earlier, my connection is dial up. Yes I still listen to vinyl and watch VHS tapes. My car has a cassette player too!:D
Paul