Varmint Hunters Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,307 Posts
You can move the wad guide up the arm where it's mounted, then change the powder bushing and shot bushings to the appropriate ones for the powder/amount of shot being used, and run with it. You won't be able to pull the handle down quite as far as you would, with 2 3/4" shells, but you won't be able to overpower anything enough to hurt it,either. Really, that's all there is to it, move the wad guide UP on the ram, and change out the bushings to the correct ones for that load (choose your wads carefully, too) and run 'em.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top