Varmint Hunters Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter · #1 ·
I came across an old 222 Rem sizing die, of unknown make, that was pretty soft steel. I decided to make a bushing type sizing die out of it that would work in a press.
I bored it out and inside threaded it in the lathe, then I turned and threaded a plug to hold the bushings in place. I then turned and bored bushing to various sizes. It works very well.



221 Fireball to 20 Fireball to 17 Fireball to 14 Fireball

 

·
Registered
Joined
·
462 Posts
Very cool, wish I could do stuff like that,

Good job

Rick
 
1 - 2 of 2 Posts
Top