Varmint Hunters Forum banner

Rebult sizing die project completed...

2K views 1 reply 2 participants last post by  gonedawgn 
#1 ·
I came across an old 222 Rem sizing die, of unknown make, that was pretty soft steel. I decided to make a bushing type sizing die out of it that would work in a press.
I bored it out and inside threaded it in the lathe, then I turned and threaded a plug to hold the bushings in place. I then turned and bored bushing to various sizes. It works very well.



221 Fireball to 20 Fireball to 17 Fireball to 14 Fireball

 
See less See more
2
#2 ·
Very cool, wish I could do stuff like that,

Good job

Rick
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top